IDEAL PRAKTIK CHARGER 8 LCD 6/12V auto charger

IDEAL PRAKTIK CHARGER 8 LCD 6/12V auto charger Intelligent portable charger for charging 6 and 12 volt acid, gel, AGM, MF, EFB batteries. Power supply 230V, charging voltage 6/12V, charging current 2/8A.. PRAKTIK CHARGER 8 is an electronic charger for charging 6 and 12 volt acid batteries:WET (liquid-acid)GEL (gel)MF (maintenance-free)AGM (with fiberglass mat)EFB (for vehicles with Start-Stop system)The charger has a microprocessor control system, provides automatic shutdown when the required voltage is reached on the battery and automatic resumption of charging after the voltage drops on the battery.Each time it is turned on, the charger automatically sets the last memorized parameters (helpful for repeated use and power outages).Cold battery charging function: optimizes charging at very low temperatures (low temperatures can adversely affect the chemical structure of battery components).Charging process9-step charging process ensures that optimal battery charging conditions are achieved. An automatic control system will adjust each of the 9 charging stages to properly charge the battery:ETAP 1 - DIAGNOSTIC (Diagnostic) - analyzes the battery and checks whether it can accept the charging current; prevents charging a damaged battery.ETAP 2 - RECOVERY CHARGE - low-voltage batteries are pre-charged with a low current but increased voltage; highly discharged batteries can be restored to a usable state and this ensures longer battery life, the stage is skipped if the battery is minimally discharged and in good condition.ETAP 3 - SOFT START - the charger gradually increases the charging current until the preset charging current is reached.ETAP 4 - PULSE CHARGE - the battery is charged with pulse current (pulse fluctuation takes place in the DC current range).ETAP 5 - RECONDITIONING - preparatory stage for charging in the bulk charge stage.ETAP 6 - BULK CHARGE - charging with a constant current up to a predetermined voltage (14.4÷14.7V).ETAP 7 - ABSORPTION CHARGE - after the battery has reached the required level of charge, there will be a change to constant voltage (CV) charging and the charging process will end.ETAP 8 - EVALUATION DIAGNOSTIC - automatic monitoring of the battery voltage after charging is completed.ETAP 9 - MAINTENANCE CHARGE - a stage that sustains the battery (float) and monitors its condition; resumes charging with reduced current if necessary. LCD DisplayDepending on the function selection, the LCD display indicates the charger's operating status:Charging in 12V free mode: 2A / 14.4VCharging in 12V fast mode: 8A / 14.4VCharging in winter mode: 8A / 14.7VRecommended for charging batteries at temperatures below 5°C.Charging in 6V mode: 2A / 7.2VBattery charge level.Information:- about no terminal connection- about incorrect terminal connectionInformation:- about wrong battery condition- about incorrectly selected charging function (ex. charging a 6V battery with a 12V mode)Information about the elevated temperature of the chargerPhysical parametersThe device is equipped with protection against short-circuiting, overloading and reverse polarity.The charger's housing is IP65 (splash-proof and dustproof). Power supply voltage :230V; 50Hz (1ph)Power: 110 WProtection rating: IP65Weight: 665g:Dimensions L x W x H 212x100x60 mmPackaging dimensions L x W x H: 68x145x280mmCharging voltage: 6 / 12 VCharging current: 2A (6V) / 2/8A (12V)Name battery capacity Ah 15h (min/max): 1.2-80Ah (6V), 10-180Ah (12V), maintenance charge up to 300Ah. EquipmentDelivery includes the device with cables. Length of power cord 160cm, length of pole wires 110cm..