IDEAL PRAKTIK CHARGER 15 LCD 12V auto rectifier

IDEAL PRAKTIK CHARGER 15 LCD 12V auto rectifier Intelligent portable charger for charging 12 volt acid, gel, AGM, MF batteries. Power supply 230V, charging voltage 12V, charging current 2/8/15A.. PRAKTIK CHARGER is an electronic charger for charging 12 volt acid batteries:WET (liquid-acid)GEL (gel)MF (maintenance-free)AGM (with fiberglass mat)EFB (for vehicles with Start-Stop system)The charger has a microprocessor control system, provides automatic shutdown when the required voltage is reached on the battery and automatic resumption of charging after the voltage drops on the battery.Each time it is turned on, the charger automatically sets the last memorized parameters (helpful for repeated use and mains outages).Charging ProcessThe 9-stage charging process ensures that optimal battery charging conditions are achieved. The automatic control system will adjust each of the 9 charging stages to properly charge the battery:ETAP 1 - DIAGNOSTIC (Diagnostic) - analyzes the battery and checks if it can accept the charging current; prevents charging a damaged battery.ETAP 2 - RECOVERY CHARGE - low-voltage batteries are pre-charged with a low current but increased voltage; highly discharged batteries can be restored to a usable state and this ensures longer battery life, the step is skipped if the battery is minimally discharged and in good condition.ETAP 3 - SOFT START - the charger gradually increases the charging current until the set charging current is reached.ETAP 4 - PULSE CHARGE - the battery is charged with a pulse current (pulse fluctuations take place in the DC current range).ETAP 5 - RECONDITIONING - preparatory stage for charging in the bulk charge stage.ETAP 6 - BULK CHARGE - charging with a constant current up to the pre-set voltage (14.4÷14.7V).ETAP 7 - ABSORPTION CHARGE - when the required level of battery charge is reached, a change to constant voltage (CV) charging will occur and the charging process will end.ETAP 8 - EVALUATION DIAGNOSTIC - automatic monitoring of the battery voltage after charging is completed.ETAP 9 - MAINTENANCE CHARGE - a stage that sustains the battery (float) and monitors its condition; resumes charging with reduced current if necessary.Function selectionCharge current selection: 2A / 8A / 15AChoose the type of battery to be charged:STD / AGM / CALDisplays the amperage value on the displayDisplays the voltage value on the displayBattery desulfurization functionLCD displayDepending on the function selection, the LCD display indicates the operating status of the charger:Charging in 12V mode : 2A / 14.4VCharging in 12V mode : 8A / 14.4VCharging in 12V mode : 15A / 14.4VBattery charge level.RegenerationInformation:- about missing terminal connection- about incorrect terminal terminal connectionInformation:- about wrong battery condition- about incorrectly selected charging function (ex. charging a 6V battery with a 12V mode)Information about the elevated temperature of the charger. Power supply voltage :230V; 50Hz (1ph)Power: 210 WProtection rating: IP20Weight: 1280gDimensions L x W x H: 215x185x75 mmPackaging dimensions L x W x H: 88x240x192mmCharging voltage :12VCharging current: 2A / 8A / 15A (12V)Name battery capacity Ah 15h (min/max): 10-300Ah (12V), maintenance charging up to 300Ah . EquipmentDelivery includes the device with cables. Length of power cord 160cm, length of pole wires 110cm..