IDEAL PRAKTIK CHARGER 25 LCD 12/24V auto charger

IDEAL PRAKTIK CHARGER 25 LCD 12/24V auto charger Intelligent portable charger for charging 12 and 24 volt acid, gel, AGM, MF, EFB, Li batteries. Power supply 230V, charging voltage 12/24V, charging current 25A(12V)/12.5A(24V). PRAKTIK CHARGER 25 is an electronic charger for charging 12 and 24 volt acid batteries:WET (liquid-acid)GEL (gel)MF (maintenance-free)AGM (with fiberglass mat)EFB (for vehicles with Start-Stop system)and 12V lithium batteriesLi (LiFePO4)The charger has a microprocessor control system, provides automatic shutdown when the required voltage is reached on the battery and automatic resumption of charging when the voltage on the battery drops.Each time it is turned on, the charger automatically sets the last memorized parameters (helpful for repeated use and mains outages).Charging ProcessThe 9-stage charging process ensures that optimal battery charging conditions are achieved. An automatic control system will adjust each of the 9 charging stages to properly charge the battery:ETAP 1 - DIAGNOSTIC (Diagnostic) - analyzes the battery and checks if it can accept the charging current; prevents charging a damaged battery.ETAP 2 - RECOVERY CHARGE - low-voltage batteries are pre-charged with a low current but increased voltage; highly discharged batteries can be restored to a usable state and this ensures longer battery life, the step is skipped if the battery is minimally discharged and in good condition.ETAP 3 - SOFT START - the charger gradually increases the charging current until the set charging current is reached.ETAP 4 - PULSE CHARGE - the battery is charged with a pulse current (pulse fluctuations take place in the DC current range).ETAP 5 - RECONDITIONING - preparatory stage for charging in the bulk charge stage.ETAP 6 - BULK CHARGE - charging with a constant current up to a pre-set voltage (14.4÷14.7V).ETAP 7 - ABSORPTION CHARGE - when the required level of battery charge is reached, a change to constant voltage (CV) charging will occur and the charging process will end.ETAP 8 - EVALUATION DIAGNOSTIC - automatic monitoring of the battery voltage after charging is completed.ETAP 9 - MAINTENANCE CHARGE - a stage that sustains the battery (float) and monitors its condition; resumes charging with reduced current if necessary.Function selectionCharge current selection: 5A / 15A / 25AChoose the type of battery to be charged:STD / AGM / CALDisplays the amperage value on the displayDisplays the voltage value on the displayCharge mode selection for 15A lithium batteries (for 12V)LCD displayDepending on the function selection, the LCD display indicates the operating status of the charger:Charging in 12V mode : 5A / 14.4VCharging in 12V mode : 15Aonly for lithium batteries (LIFeP04)Charging in 12V mode : 25A / 14.4VCharging in 24V mode : 12.5A / 28.8VBattery charge levelInformation:- about no terminal connection- about incorrect terminal connectionInformation:- about wrong battery condition- about incorrectly selected charging function (ex. Charging a 6V battery with a 12V mode)Information about the elevated temperature of the charger. Power supply voltage: 230V; 50Hz (1ph)Power: 345 WProtection rating: IP20Weight: 1.7kgDimensions L x W x H: 120x250x265mmPackaging dimensions L x W x H: 126x252x268mmCharging voltage: 12/24VCharging current: 5/25A (12V) / 15A (12V LiFePO4) / 12.5A (24V)Fast charging current (boost): 25ARated Ah 15h battery capacity (min/max): 10-500Ah (12V), 75-250Ah (24V) / 45-300Ah (Li-Ion). EquipmentDelivery includes the device with cables. Length of power cord 160cm, length of pole wires 110cm..