Inverter MMA/TIG Welder ARC 207 WALKER 60%. Inverter welder ARC 207does direct current (DC) covered electrode welding and TIG lift.Designed for welding with rutile and basic electrodes up to 5 mm of various steels (low-carbon, low-alloy, stainless, etc.) and cast iron.The welder has a digital display of welding current.LEDs on the front panel indicate power connection (green LED) or shutdown due to overload (red LED).Electronically controlled stepless welding current control.Overload protection.The welder has functions to facilitate welding:- HOT START (hot start): increases welding current during arc ignition to facilitate electrode ignition- ARC FORCE (arc dynamics): shortens the arc length when increasing the welding current optimizing the transfer of molten electrode droplets to the material being welded, preventing arc extinction when the electrode comes into contact with the material being welded- ANTI STICK: limits the welding current preventing the electrode from sticking to the material being weldedThe welder can TIG weld when connected to a gas valve holder. Touch ignition of the welding arc due to rubbing the tungsten electrode against the material to be welded (TIG Scratch).. The welder comes with the following equipment:power cable 2 m with 230V plugwelding cable 2 m with electrode holder 200A (DX25)ground cable 1.6 m with clamp 200A (DX25)welding discwelding hammeraluminum case Technical dataCode: 103 014Device type: ARC 207Power supply voltage [V]: 230Idle current voltage [V]: 56Welding current adjustment range [A]: 20-200Electrode diameter [mm]: 2-4Protection class [IP]: 21Dimensions [cm]: 38×12.5×24Weight [kg]: 5.5. Small and lightweight design makes the device applicable for repair work in workshop conditions as well as for work performed in the field.Transport is facilitated by equipping the welder with a shoulder strap. WeIGHT OF ONLY 7KG. WeIGHT OF ONLY 7KG.