Hydraulic line M18x1.5 KK10/2 L-200 330Bar

Hydraulic hose with two 90° elbows KK 10/2 M18x1.5, 2-slot (2SN), 330 Bar, L-200 mmFlexible hydraulic hoses, next to rigid seamless pipes, are used in every hydraulic system for fluid transfer. Their big advantage is flexibility which gives wide possibilities of installation and arrangement in the system, even in hard-to-reach places. In case of damage, failure or leakage, these hoses can be easily replaced with a new model according to specific specifications.The North-Fighter Hydraulic Hose complies with EN 853 2SN standards while offering an attractive price. It is an ideal choice for hydraulic systems with working pressure not exceeding 330 Bar.Hose specifications:Indrical diameter: 10 mm; 3/8"; dash: -06external diameter: 18 mminternal layer: synthetic rubberreinforcement: 2 braided steel wireexternal layer: synthetic rubberworking pressure: 330 Barburst pressure: 1320 Barbending radius: 130 mmtemperature range: -40°C +100°Cstandard: EN 853 2SNCable having DKOL-90 metric elbow ends on both sides with M18x1.5 12L female thread (nut)Cable specification:length L - 200 mmend 1: DKOL-90° M18x1.5 12Lend 2: DKOL-90° M18x1.5 12LWe are able to manufacture hose in any size required!All our hydraulic hoses are cleaned at the appropriate stage of production, so you can be sure to receive a product ready for installation and be assured of long service!To be able to determine the flow value of a given hose size you need to use the appropriate table (see opposite).Data is selected depending on the type of hose:pressure line (supply)suction or return lineTo determine the size of the appropriate diameter of hydraulic hose you need a ruler, one end of which is applied to the flow value (left line), the other to the flow speed value (right line), depending on where the hose is used.Flow velocity lines have ranges of values, which depend on the individual characteristics of the system.To determine the best parameters, you need to choose the average value of the range by rounding the duct dimension to the full size above the indication.Designing and selecting cables for a given circuit also need to pay attention to:tip twist angle, this applies to the following types of cables: elbow:elbow, mesh:eyelet, elbow-eyeletselection of the appropriate type of termination depending on the location and operating position of the hoseselection of the bending radius of the hoseprevent twisting of the hose during installation which may cause early wearappropriate protection of the hose from premature wear.In the comments in the order, please specify the angle of twist of the tips!!We offer many varieties of tips and hydraulic hoses. If you have not found the solution you are interested in or are looking for a tailor-made product, you will find it with us!Our hoses are manufactured on the basis of the order received!Return of ordered products possible after prior approval by the seller. Otherwise, 50% of the value of the goods will be returned!