DRYPOINT M PLUS 20-48A membrane dehumidifier

Membrane dryer with built-in filter Best membrane dehumidifier technology with integrated nanofilter Filtration and dehumidification in one housing (simple filter cartridge replacement) Low demand for purification air (Twist 60 technology) Availability of dried compressed air immediately, without run-in phase Safe drying due to high vapor partial pressure gradient No changes in temperature or compressed air composition Tested 100, 000 times Maintenance-free (except for filter element replacement) For a variety of applications, including breathing air treatment Also excellent for use directly downstream of compressor / aftercooler Also optional for higher loads (pot mounting, 16 bar, 70°C) To ensure reliable operation, the DRYPOINT M membrane dryer must meet the following requirements: The incoming compressed air must not contain any liquid condensates Particles larger than 1 ?m must be separated before the membrane dryer The oil content of the compressed air must not exceed 0. 01 mg/m? Diaphragm dryersDRYPOINT M have been an alternative to existing compressed air dryers for years. Advantages of DRYPOINT M PLUS A proven process with superior reliability and functional safety Immediate availability of dry compressed air, even in intermittent operation Low purge air requirement, compressed air drying can be adapted to the application Compact and robust design, low space requirements due to low overall height Compressed air inlet and outlet on one level (filter version), easy to combine with CLEARPOINT filters Maintenance-free and wear-free because there are no moving parts Does not reduce oxygen content, so it is also suitable for breathing air treatment Without electrical connection, also suitable for Ex areas Long service life when using CLEARPOINT filters Environmentally friendly, no need for refrigerants or CFC-containing adsorbents Complete solution: filtration and dehumidifier in a compact form, drain pipe integration Filtration at the point in the purification chain where the highest efficiency is achieved Easy maintenance/replacement of the filter cartridge as with an ordinary filter Filter element: N (nanofilter) CLEARPOINT N-type filter element is used for the separation of solid particles down to 0.01 microns, water and oil aerosols. The element has a multi-stage design for effective and long-lasting filtration. In the first stage, coarse particles are retained by a pre-filter layer. In the second stage, finer particles are absorbed by a filter bed made of high-performance borosilicate fiber fabric. Due to the very large void volume of the filter medium (96%), a very high dirt holding capacity is achieved. The filter medium is specially impregnated to avoid swelling of individual fibers in the cross section. Trap: float trap The basic version includes a float drain. Size 10 - 40 This size is designed for demand-oriented compressed air drying for configured medium volume flows. Different levels of compressed air drying are achieved through different purge air settings. Special Drying by partial pressure compensation of water vapor by diffusion in combination with a highly selective membrane No change in compressed air composition - can be used for breathing air treatment Efficient Achieves the required pressure dew point with low energy consumption Very fast availability of dried compressed air Compact filtration and drying in one unit Robust Seawater-resistant aluminum housing Maintenance-free, current-free technology Compatible with the system Can be modularly combined with CLEARPOINT Filter program Can be used anywhere in the compressed air treatment chain - can be integrated into system technology Air treatment at a pressure of 7 bar 60 l/min Maximum pressure of 12.5 bar Air connection G 3/4 " Volume flow inlet Volumetric airflow inlet (DTP reduction from +35°C to +15°C (+5°C to -7°C)) 600 l/min Volumetric airflow inlet (DTP reduction from +35°C to +3°C (+5°C to -17°C)) 399 l/min Volumetric airflow inlet (DTP reduction from +35°C to -10°C (+5°C to -26°C)) 297 l/min Volumetric airflow inlet (DTP reduction from +35°C to -20°C (+5°C to -33°C)) 253 l/min