MAGNUM CUT 45 COMPRESSOR MMA plasma cutter

carbon and alloy steels, . aluminum and its alloys, . brass, copper, as well as cast iron . and MMA covered electrode welding. . The cutter can be used for workshop work, repair work, etc. The built-in compressor provides great convenience and mobility of the device. In this model, the appropriate pressure parameters and air flow are taken care of by the built-in control system. The device is equipped with a torch that allows cutting in hard-to-reach places and in all possible positions. The device is equipped with the "BLOW-BACK" non-contact arc ignition system. This method is based on the retraction of the electrode during arc ignition. The big advantage of this solution is less wear and tear of consumable components and minimization of electromagnetic interference, compared to HF ignition. This has a major impact on the protection of electrical equipment such as controllers, stepper motors, etc. An additional advantage is the lower failure rate of the device, by eliminating the HF module. MAGNUM CUT 45 COMPRESSOR is built on the basis of the latest technology using IGBT transistors, which translates into reduced electromagnetic interference, low power loss, increased efficiency and reliability of the power source, and reduced power consumption. The cutter is equipped with overload thermal protection. Its advantage is low weight and infinitely adjustable cutting current to ensure high quality material cutting. carbon and alloy steels, . aluminum and its alloys, . brass, copper, as well as cast iron . and MMA covered electrode welding. . The cutter can be used for workshop work, repair work, etc. The built-in compressor provides great convenience and mobility of the device. In this model, the appropriate pressure parameters and air flow are taken care of by the built-in control system. The device is equipped with a torch that allows cutting in hard-to-reach places and in all possible positions. The device is equipped with the "BLOW-BACK" non-contact arc ignition system. This method is based on the retraction of the electrode during arc ignition. The big advantage of this solution is less wear and tear of consumable components and minimization of electromagnetic interference, compared to HF ignition. This has a major impact on the protection of electrical equipment such as controllers, stepper motors, etc. An additional advantage is the lower failure rate of the device, by eliminating the HF module. MAGNUM CUT 45 COMPRESSOR is built on the basis of the latest technology using IGBT transistors, which translates into reduced electromagnetic interference, low power loss, increased efficiency and reliability of the power source, and reduced power consumption. The cutter is equipped with overload thermal protection. Its advantage is low weight and infinitely adjustable cutting current to ensure high quality material cutting. TECHNICAL DATA: Cutting current: 20 - 45 [A],. MMA welding current:20-200 [A],. Efficiency: 60[%],. Power supply: 230 [V] / 50 [Hz],. Power supply protection: 20 [A] / [C],. Power consumption: 6.5 [kVA],. Approximate cutting thickness for structural steel: split max. 13 [mm], qualitative max. 9 [mm],. Arc initiation: contactless,. Function: 2T/4T,. Required air pressure:5 [bar],. Air consumption:115 [l/min],,. Case protection: IP21S,. Cooling: Air - fan,. Idle voltage: 330 [V],. Net weight: 17.3 [kg]..