FLUX MIG TIG MMA 200A GASLESS WELDING MACHINE

. FLEX MIG MIG TIG MMA 200A non-gas welding machineKraft&Dele KD1872Condition: New productMIG/MMA 200A welding machineBrand: Kraft&DeleModel: KD1872Welding functions: MIG / MMASmooth welding current control: 40-200A SPECIFICATION:Voltage: 220VFrequency: 50/60HzName input current: 30AOutput current:MIG: 40-200AMMA: 20-200AOutput vol: 15.5-24VWork cycle: 60%Power factor: 0.73Efficiency: 80%Speed: 2-13(m/min)Final discharge: 1SWire wheel diameter: 200mmWire diameter: 0.8-1.0mmCasing rating: IP21Insulation rating: FWeight: 6kg. The KLraft&Dele Professional Series is a semi-automatic welding machine designed for manual, electric welding of steel with self-cored wire (FCAW Flux-Cored Arc Welding method).TheFCAW method is arc welding with flux-cored (powder) wire.It is a welding method similar to the MIG/MAG method, except that the wire is internally filled with flux or a chemical that produces protective gases during welding.FCAW welding combines the advantages of both covered electrode and MAG welding: very high productivity (no need for frequent electrode changes) can also be welded outdoors (flux also protects against oxidation of the weld) the welder does not need to have very high qualifications.It is designed for all kinds of welding work, in locksmith shops, repair shops, sheet metal workshops, farms, etc.The power source was built onIGBT transistors ensuring minimum electromagnetic interference, low power loss in the basic circuits, allowing increased efficiency and reliability of the power source.. HOT STARTcalled popularly known as hot start, it allows by temporarily increasing the welding current above the value set by the welder. HOT START works at the moment of arc ignition and is designed to prevent the electrode from sticking electrode to the material. It is a great convenience when igniting the electrode.ANTI STICKcuts/minimizes voltage and current. welding in the event of a short-circuit of the electrode with the material being welded. ANTI STICK allows the welder to more easily detach the electrode.ARC FORCEstabilizes the the arc regardless of its length. It regulates the dynamics of the welding arc. Decreasing the values of the function gives a soft arc and a smaller depth of fusion fusion, while increasing the function values results in deeper fusion and the possibility of short arc welding. At the highest value for the ARC FORCE function it is possible to "push the electrode into the molten metal pool and burn through. molten metal and burn through the material thoroughly.. The single-roll feeder works with 0.8 / 0.9mm diameter wire.KIT CONTENT:Welder KD1872 Hand maskBrush with hammerMMA cableMass cableMIG cableMIG handleInstruction manual Original packaging.