Stepper driver 5.6A 20-50V

5.6A 50V stepper motor controller with CNC microstepper - Supply voltage 20 - 50V DC - Max. current per motor phase up to 5.6A - Max. 400kHz input pulse frequency - inaudible switching frequency - perfectly quiet operation - input control signals optically isolated , TTL compatible - automatic current reduction at idle - low heat dissipation - configuration of current per motor and microsteps via micro switches - 14 selectable operating modes using microsteps with both binary and decimal step division - microstep resolution of up to 51200 steps per revolution - suitable for 4, 6 and 8 wire - protection against overload, overvoltage and short-circuit , high temperature - small size (118x75x33 mm)Configuration switches - 8 two-state configuration switches are available.A switch set on the heatsink side means on. The functions of the switches are as follows: Current SW1 SW2 SW3phase current 1.5A 2.0A 2.4A 2.8A 3.2A 3.7A 4.2A 4.5A Micro step division per revolution SW5 SW6 SW7 SW8 micro step mode for motor 1.8 2/ 400 , 4/ 800 , 8 /1600 ,16/3200, 32/6400, 64/ 12800 , 128/ 25600 ,256/ 512005/ 1000 ,10/ 2000, 25/ 5000 ,50/ 10000 ,125/ 25000 ,250/ 50000 SW4 - rest current; if this switch is disconnected then the current used at rest will be twice as low as when moving.SK5045 is a stepper motor controller with microsteps based on advanced world technology. It can control any 2-phase or 4-phase stepper motor. Using the SK5045 control allows you to get more speed and more power from the same motor. Without any problems, you can achieve 20cm per second speed in the machines and 6000rpm speed on CNC PROFI motors . Professional performance allows for use in CNC plotters, CNC milling machines, CNC lathes, robots, manipulators. owanych in any industry, especially where reliability and reasonable price is required.