Pump 1L for central lubrication

Pump for central lubrication 1L Automatic oil pump for central lubrication. The adjustable operating time is 1-60 seconds, and the intermittent time is 3-999 minutes, which can be adjusted according to the needs of mechanical equipment. It is suitable for lubricating CNC machine tool guides, woodworking machines, gears , guides and chains. It is used with to achieve the effect of regular and quantitative automatic oil feeding without manual operation. Parameter: Electric central lubrication oil pump Oil pump volume: 1,5L Volume ratio: ≥75% Pressure rating: 1.0 MPa / 10 kg Capacity: 50 ml/min Voltage: 220 V 50 Hz Power: 28W Current: 0.35A Oil viscosity: 15-68 c.st Switch-on time: 1 ~ 60 seconds Break time: 3 ~ 999 minutes Output M8*1, for oil hose:fi 4mm Instructions for central lubrication pump Installation is enough to connect directly to 220V 50Hz power source. The oil pump is equipped with an oil level alarm. When the oil level is insufficient, an alarm can be triggered in advance to refill the oil in time. The oil pump has an adjustment range for on and off time. The operating time setting is 1-60 seconds and the interruption time from 3-999 minutes. The outlet of the oil pump is M8*1, for Ø4 mm oil hose . Attention: Immediately after installation, there will be air inside the oil pump, please remove it first. Connect the oil pump to the machine, set the running time to 30 seconds (or longer), wait for the oil pump to fill the oil into the lines , and then change it to the required time. Please use it in the recommended range (running time 1-60 seconds and intermittent time 3-999 minutes). The oil pump is not pumping oil or is pumping little oil reason: 1. the direction of rotation is incorrect. 2. air leakage in the suction line. 3. The suction height is too high and exceeds the rated value. 4. The pipe is blocked or the valve is closed. 5. The fluid viscosity increases due to low temperature. 6. The gearbox and pump body are seriously damaged. method: 1. Improve the oil absorption surface or reduce the pipe resistance. 2.Check each joint for air or liquid leakage and add and other sealing materials to seal it. 3. correct the steering according to the direction indicated by the pump. 4. remove the blockage and open the valve. 5. heat the liquid, if not, reduce the discharge pressure and reduce the oil flow. 6. disassemble and check the relevant parts and replace them. We have pumps for central lubrication Art. Nr. PS500 Manual pump 500 ml Art.-No. PS1000 Electric pump 1 L for central lubrication Art.-No. PS1500 Electric pump 1,5 L for central lubrication