INDUCTOR 8 IHD500 is a revolutionary induction heater for rapid flameless heating of ferrous metals and aluminum by induction.Using the rules of electromagnetic induction, it can deliver a tremendous amount of heat to a specific spot in just seconds to a depth of 5mm. It heats metal to 'red' (temperature of about 1000˚C) in an area of 8x13mm and 5mm thick in 1 second. By heating only the selected area, it does not damage glass, rubber, plastic parts and painted surfaces in the immediate vicinity of the heater's work.Recommended for any passenger and commercial vehicle service for body and mechanical repairs. For use in overhaul and wheel alignment, tire changers and mechanic shops. Facilitates removal of locked bolts, nuts, pins, bearings and other automotive parts.Guarantees reduced repair time and maximum control of heating during operation. Unlike a gas burner - the induction heater, heating the metal only in the selected area to a temperature of 500-600˚C, does not change the technical characteristics of the steel. The induction heater is not a gas burner. Power adjustable in steps of 10%. Power supply parameters. Single-phase 230V power supply. Power supply. INDUCTOR 8 IHD500 is a revolutionary induction heater for rapid flameless heating of ferrous metals and aluminum by induction.Using the rules of electromagnetic induction, it can deliver a tremendous amount of heat to a specific spot in just seconds to a depth of 5mm. It heats metal to 'red' (temperature of about 1000˚C) in an area of 8x13mm and 5mm thick in 1 second. By heating only the selected area, it does not damage glass, rubber, plastic parts and painted surfaces in the immediate vicinity of the heater's work.Recommended for any passenger and commercial vehicle service for body and mechanical repairs. For use in overhaul and wheel alignment, tire changers and mechanic shops. Facilitates removal of locked bolts, nuts, pins, bearings and other automotive parts.Guarantees reduced repair time and maximum control of heating during operation. Unlike a gas burner - the induction heater, heating the metal only in a selected area to a temperature of 500-600˚C, does not change the technical characteristics of the steel. The induction heater is not a gas burner. Power adjustable in steps of 10%. Power supply parameters. Single-phase 230V power supply. Power supply. Current drawn from the mains 24A (peak) Mains protection 25A delayed Rated supply voltage 230V; 50Hz/60Hz (1ph) Length of complete cable 3 m Tank capacity 20 liters Type of cooling liquid Degree of protection IP 21 Weight 65kg with refrigerant Overall dimensions L x W x H 43x43x104 cm Continuous operation time more than 30 minutes at maximum power Frequency 15-50 kHz automatically adjustable Continuous power 5.4 kW Maximum power 8 kW Heating power (temperature about 1000˚C) 8x13x5mm in 1 second Adjustment steps 10